Results 1 - 10
of
239
Single-ISA Heterogeneous Multi-Core Architectures: The Potential for Processor Power Reduction
, 2003
"... This paper proposes and evaluates single-ISA heterogeneous multi-core architectures as a mechanism to reduce processor power dissipation. Our design incorporates heterogeneous cores representing different points in the power/performance design space; during an application 's execution, system s ..."
Abstract
-
Cited by 348 (22 self)
- Add to MetaCart
This paper proposes and evaluates single-ISA heterogeneous multi-core architectures as a mechanism to reduce processor power dissipation. Our design incorporates heterogeneous cores representing different points in the power/performance design space; during an application 's execution, system software dynamically chooses the most appropriate core to meet specific performance and power requirements.
Speculative Lock Elision: Enabling Highly Concurrent Multithreaded Execution
, 2001
"... Serialization of threads due to critical sections is a fundamental bottleneck to achieving high performance in multithreaded programs. Dynamically, such serialization may be unnecessary because these critical sections could have safely executed concurrently without locks. Current processors cannot f ..."
Abstract
-
Cited by 227 (10 self)
- Add to MetaCart
(Show Context)
Serialization of threads due to critical sections is a fundamental bottleneck to achieving high performance in multithreaded programs. Dynamically, such serialization may be unnecessary because these critical sections could have safely executed concurrently without locks. Current processors cannot fully exploit such parallelism because they do not have mechanisms to dynamically detect such false inter-thread dependences. We propose Speculative Lock Elision (SLE), a novel micro-architectural technique to remove dynamically unnecessary lock-induced serialization and enable highly concurrent multithreaded execution. The key insight is that locks do not always have to be acquired for a correct execution. Synchronization instructions are predicted as being unnecessary and elided. This allows multiple threads to concurrently execute critical sections protected by the same lock. Misspeculation due to inter-thread data conflicts is detected using existing cache mechanisms and rollback is used for recovery. Successful speculative elision is validated and committed without acquiring the lock. SLE can be implemented entirely in microarchitecture without instruction set support and without system-level modifications, is transparent to programmers, and requires only trivial additional hardware support. SLE can provide programmers a fast path to writing correct high-performance multithreaded programs.
AVIO: Detecting Atomicity Violations via Access Interleaving Invariants
- In ASPLOS
, 2006
"... Abstract Concurrency bugs are among the most difficult to test and diagnoseof all software bugs. The multicore technology trend worsens this ..."
Abstract
-
Cited by 192 (26 self)
- Add to MetaCart
(Show Context)
Abstract Concurrency bugs are among the most difficult to test and diagnoseof all software bugs. The multicore technology trend worsens this
Hyperthreading technology architecture and microarchitecture.
- Intel Technical Journal,
, 2002
"... ABSTRACT Intel's Hyper-Threading Technology brings the concept of simultaneous multi-threading to the Intel Architecture. Hyper-Threading Technology makes a single physical processor appear as two logical processors; the physical execution resources are shared and the architecture state is dup ..."
Abstract
-
Cited by 182 (1 self)
- Add to MetaCart
ABSTRACT Intel's Hyper-Threading Technology brings the concept of simultaneous multi-threading to the Intel Architecture. Hyper-Threading Technology makes a single physical processor appear as two logical processors; the physical execution resources are shared and the architecture state is duplicated for the two logical processors. From a software or architecture perspective, this means operating systems and user programs can schedule processes or threads to logical processors as they would on multiple physical processors. From a microarchitecture perspective, this means that instructions from both logical processors will persist and execute simultaneously on shared execution resources. This paper describes the Hyper-Threading Technology architecture, and discusses the microarchitecture details of Intel's first implementation on the Intel Xeon processor family. Hyper-Threading Technology is an important addition to Intel's enterprise product line and will be integrated into a wide variety of products.
Managing Wire Delay in Large Chip-Multiprocessor Caches
- IEEE/ACM INTERNATIONAL SYMPOSIUM ON MICROARCHITECTURE
, 2004
"... In response to increasing (relative) wire delay, architects have proposed various technologies to manage the impact of slow wires on large uniprocessor L2 caches. Block migration (e.g., D-NUCA and NuRapid) reduces average hit latency by migrating frequently used blocks towards the lower-latency bank ..."
Abstract
-
Cited by 156 (4 self)
- Add to MetaCart
In response to increasing (relative) wire delay, architects have proposed various technologies to manage the impact of slow wires on large uniprocessor L2 caches. Block migration (e.g., D-NUCA and NuRapid) reduces average hit latency by migrating frequently used blocks towards the lower-latency banks. Transmission Line Caches (TLC) use on-chip transmission lines to provide low latency to all banks. Traditional stride-based hardware prefetching strives to tolerate, rather than reduce, latency. Chip multiprocessors (CMPs) present additional challenges. First, CMPs often share the on-chip L2 cache, requiring multiple ports to provide sufficient bandwidth. Second, multiple threads mean multiple working sets, which compete for limited on-chip storage. Third, sharing code and data interferes with block migration, since one processor's low-latency bank is another processor's high-latency bank. In this paper, we develop L2 cache designs for CMPs that incorporate these three latency management techniques. We use detailed full-system simulation to analyze the performance trade-offs for both commercial and scientific workloads. First, we demonstrate that block migration is less effective for CMPs because 40-60% of L2 cache hits in commercial workloads are satisfied in the central banks, which are equally far from all processors. Second, we observe that although transmission lines provide low latency, contention for their restricted bandwidth limits their performance. Third, we show stride-based prefetching between L1 and L2 caches alone improves performance by at least as much as the other two techniques. Finally, we present a hybrid design-combining all three techniques-that improves performance by an additional 2% to 19% over prefetching alone.
Cooperative caching for chip multiprocessors
- In Proceedings of the 33nd Annual International Symposium on Computer Architecture
, 2006
"... Chip multiprocessor (CMP) systems have made the on-chip caches a critical resource shared among co-scheduled threads. Limited off-chip bandwidth, increasing on-chip wire delay, destructive inter-thread interference, and diverse workload characteristics pose key design challenges. To address these ch ..."
Abstract
-
Cited by 144 (1 self)
- Add to MetaCart
(Show Context)
Chip multiprocessor (CMP) systems have made the on-chip caches a critical resource shared among co-scheduled threads. Limited off-chip bandwidth, increasing on-chip wire delay, destructive inter-thread interference, and diverse workload characteristics pose key design challenges. To address these challenge, we propose CMP cooperative caching (CC), a unified framework to efficiently organize and manage on-chip cache resources. By forming a globally managed, shared cache using cooperative private caches. CC can effectively support two important caching applications: (1) reduction of average memory access latency and (2) isolation of destructive inter-thread interference. CC reduces the average memory access latency by balancing between cache latency and capacity opti-mizations. Based private caches, CC naturally exploits their access latency benefits. To improve the effective cache capacity, CC forms a “shared ” cache using replication control and LRU-based global replacement policies. Via cooperation throttling, CC provides a spectrum of caching behaviors between the two extremes of private and shared caches, thus enabling dynamic adaptation to suit workload requirements. We show that CC can achieve a robust performance advantage over private and shared cache schemes across different processor, cache and memory configurations, and a wide selection of multithreaded and multiprogrammed
Exploring interconnections in multi-core architectures
, 2005
"... This paper examines the area, power, performance, and design issues for the on-chip interconnects on a chip multiprocessor, attempting to present a comprehensive view of a class of interconnect architectures. It shows that the design choices for the interconnect have significant effect on the rest o ..."
Abstract
-
Cited by 128 (6 self)
- Add to MetaCart
(Show Context)
This paper examines the area, power, performance, and design issues for the on-chip interconnects on a chip multiprocessor, attempting to present a comprehensive view of a class of interconnect architectures. It shows that the design choices for the interconnect have significant effect on the rest of the chip, potentially consuming a significant fraction of the real estate and power budget. This research shows that designs that treat interconnect as an entity that can be independently architected and optimized would not arrive at the best multicore design. Several examples are presented showing the need for careful co-design. For instance, increasing interconnect bandwidth requires area that then constrains the number of cores or cache sizes, and does not necessarily increase performance. Also, shared level-2 caches become significantly less attractive when the overhead of the resulting crossbar is accounted for. A hierarchical bus structure is examined which negates some of the performance costs of the assumed baseline architecture. 1
Mitigating amdahl’s law through epi throttling
- In Proceedings of International Symposium on Computer Architecture
, 2005
"... This paper is motivated by three recent trends in computer design. First, chip multi-processors (CMPs) with increasing numbers of CPU cores per chip are becoming common. Second, multi-threaded software that can take advantage of CMPs will soon become prevalent. Due to the nature of the algorithms, t ..."
Abstract
-
Cited by 121 (7 self)
- Add to MetaCart
(Show Context)
This paper is motivated by three recent trends in computer design. First, chip multi-processors (CMPs) with increasing numbers of CPU cores per chip are becoming common. Second, multi-threaded software that can take advantage of CMPs will soon become prevalent. Due to the nature of the algorithms, these multi-threaded programs inherently will have phases of sequential execution; Amdahl’s law dictates that the speedup of such parallel programs will be limited by the sequential portion of the computation. Finally, increasing levels of on-chip integration coupled with a slowing rate of reduction in supply voltage make power consumption a first order design constraint. Given this environment, our goal is to minimize the execution times
Exploring the Design Space of Future CMPs
, 2001
"... In this paper, we study the space of chip multiprocessor (CMP) organizations. We compare the area and performance trade-offs for CMP implementations to determine how many processing cores future server CMPs should have, whether the cores should have in-order or out-of-order issue, and how big the pe ..."
Abstract
-
Cited by 107 (13 self)
- Add to MetaCart
(Show Context)
In this paper, we study the space of chip multiprocessor (CMP) organizations. We compare the area and performance trade-offs for CMP implementations to determine how many processing cores future server CMPs should have, whether the cores should have in-order or out-of-order issue, and how big the per-processor on-chip caches should be. We find that, contrary to some conventional wisdom, out-of-order processing cores will maximize job throughput on future CMPs. As technology shrinks, limited off-chip bandwidth will begin to curtail the number of cores that can be effective on a single die. Current projections show that the transistor/signal pin ratio will increase by a factor of 45 between 180 and 35 nanometer technologies. That disparity will force increases in per-processor cache capacities as technology shrinks, from 128KB at 100nm, to 256KB at 70nm, and to 1MB at 50 and 35nm, reducing the number of cores that would otherwise be possible.
