"... In PAGE 2: ... The re- lationship between the static features and those augmented with derived dynamic features can be arranged in matrix form, V TD TB TT ULLLLI Figure 2: Placement of EMA receiver coils in the MOCHA database. See Table1 for the key to abbreviations In this paper, we used the 6 EMA channels for the tongue (x- and y-coords for... ..."

"... In PAGE 6: ... Thus, no readjustment of the position of the paddle was necessary. For each position of the coil/phantom in the scanner, the measured SAR increases from sensor 1 to sensor 5 (from the inside of the phantom to the edge of the phantom) ( Table1 ). The SAR increases when the coil is discon- nected from the scanner surface coil port (when the de- coupling of the receive coil is disabled ( failure mode )) (Table 1, position b).... In PAGE 6: ... For each position of the coil/phantom in the scanner, the measured SAR increases from sensor 1 to sensor 5 (from the inside of the phantom to the edge of the phantom) (Table 1). The SAR increases when the coil is discon- nected from the scanner surface coil port (when the de- coupling of the receive coil is disabled ( failure mode )) ( Table1 , position b). The SAR increases when the phan- tom/coil is moved toward the scanner bore (closer to the RF transmitting body coil) (Table 1, position c).... In PAGE 6: ... The SAR increases when the coil is discon- nected from the scanner surface coil port (when the de- coupling of the receive coil is disabled ( failure mode )) (Table 1, position b). The SAR increases when the phan- tom/coil is moved toward the scanner bore (closer to the RF transmitting body coil) ( Table1 , position c). Position- ing the phantom/coil close to the wall of the scanner bore and disconnecting the coil from the surface coil port (Ta- ble 1, position d) gives maximal SAR (5.... ..."

"... In PAGE 10: ...Table 1: MSS Coil Dimensions Due to ergonomic constraints, the coils centered on the X a112 and Y a112 axes are identical, whereas the two coils centered on the Za112 axis are slightly flattened and closer together. The physical dimensions of these coils are given in Table1 .... ..."

"... In PAGE 6: ... In fact, this heuristic is used to identify the area where good designs are likely to exist, so that the actual space that needs to be searched can be significantly reduced. The actual boundaries used are listed in Table2 in which the axial length and inner radius were the same as before and the major change was the boundaries of axial position. Unlike in previous experiments where each coil was allowed to move freely along the Z-axis, all coils were restricted to some smaller ranges with possible overlapping (i.... In PAGE 6: ... The boundaries used for this 8-coil design are listed in Table 3. Compared to Table2 , the only change is that a single coil #2 replaced coils #2 amp; #3. Experimental results show that reducing the number of coils led to increasing performance of EDAmvg.... ..."

"... In PAGE 63: ...tiffness). A depth of 1/2 in. was selected. This geometry is pictured in Figure 16. The relevant attributes of the coil are listed in Table12 . Note that the choice of wire gauge is somewhat arbitrary.... ..."